Teak Decking Caulk

Teak Decking Caulking & Seam Condition

Teak decking caulking and seam condition is a critical indicator of the deck’s quality. Inspecting the caulking and seams can determine the overall deck condition, teak deck thickness, and remaining life of the deck.

Missing or Detached Caulking

On a dry deck, examine the seams between the planks to look for missing or detached caulking. If no caulk seam failures are visible, wet the deck. As the deck dries, look for areas along the edges of the caulk seams that stay wet longer than the surrounding teak. This is where caulk failures may exist.

Detached Teak Deck Caulking
Detached Caulking – Allows Water Penetration

Varying Seam Width

For quality teak decking caulking, the width of caulk seams will not vary along the length of the seam. If the seam widths vary, the deck was either poorly laid, or the seams have been re-cut and re-seamed. A deck in this condition may be in the last third of its life.

Caulking Condition

Cracked or hard caulk cannot flex as the teak expands and contracts. This may result in leaks. The only solution is to remove the old caulk and re-caulk the seams if there is enough seam depth available.

Cracked Caulk Teak Deck
Cracked Caulk – Allows Water Penetration

Teak Condition

Where caulking is visibly separated from the teak or missing, look at the edges of the teak where the caulking should be bonded. If the teak edges of the seams are very thin relative to the width of the seam, there is no longer enough bonding surface for new caulking to stay attached.  

If the teak surface is ridged, it will need to be sanded. It is possible the sanding will reduce the thickness so there may not be enough viable edging for re-caulking.  

Ridged Teak Deck
Extreme Ridged Surface of a Teak Deck

Determining Teak Thickness

When inspecting teak thickness, be aware that it will not be the same everywhere. Typically, bows, sun decks, uncovered aft decks, and swim platforms wear faster due to more sun, sea, and human activity.  

Hatches

The deck’s current thickness often can be determined by simply opening hatches and looking at the edges of the hatches and the deck surrounding the hatch.

Measure Caulk Seam Depth

A slightly more invasive measuring procedure is to (1) slide the tip of a penknife or ice pick into a caulking seam until it bottoms out, (2) mark the deck surface with your thumbnail, and (3) withdraw the pen or pick to see the depth.  

Rabbeted Decks – Caution Needed to Measure

In traditionally laid teak decks, one or both edges of the planks can be rabbeted. A rabbet is a notch, usually square, cut into the edge of a board. Rabbets create the space for the caulking while leaving the bottom of the plank full width to serve as a spacer for the caulk seam. 

When using the penknife or ice pick procedure to check the thickness of a traditionally laid teak deck, it is necessary to know where the edges of the two planks meet under the caulking – in the center or along one edge of the seam. This enables proper placement of the blade or a pick to reach the bottom of the deck, between the planks.

If there is sufficient teak thickness in a rabbeted deck, the existing caulk seams can be cut deeper to create the proper bonding surfaces and then be re-caulked, thereby saving the deck for several more years. Sometimes, the downside is that the process of cutting the seams deeper is not as accurate as of the original machining of the wood. As a result, once caulked and sanded, the seams will vary slightly in width and not be as crisp as the original ones.

Source: “Proper Seam Composition” by Teakdecking Systems (Rabbeted Deck on left)

Read more…Teakdecking Systems 16-pp Guide on How to Properly Caulk Seams

Cost of Reseaming vs. New Teak Deck

The cost to reseam a teak deck is lower than buying a new teak deck. Often, it is one-third to one-half the cost of a new teak deck.

BEST TIPS FOR EXTENDING DECK’S LIFE

Hopefully, the inspection of teak decking caulking will reveal little more than the need for some love and attention. To extend the deck’s life and push off the eventual replacement as long as possible, it is imperative to keep the deck fully sealed from water intrusion. Trapped water under the deck planks can cause deck delamination from beneath. It can also leak into the structural sub-deck (and possibly interior) through hardware fastener holes. For these reasons, it is important to replace any missing bungs and reseal any caulk seams with damage. If the deck cannot be properly sealed after these steps, a deck replacement is necessary.

A careful survey of a teak decking (and caulk and seams) by an expert can provide the best information about teak decking condition. This can help to determine if a deck should be repaired or replaced.

Watch for more information in this blog about the procedures and options for replacing a worn-out teak deck.

caulk, caulking, deck, decking, SIS440, teak


Karen Ross

Marketing manager

Leave a Reply


Commitment. Performance. Integrity.

An Employee-Owned Company

7061 15th East, Sarasota, Florida 34243 | Tel:  941-756-0600 | Fax: 941-756-0406  |  Request QuoteApply Now


 Copyright 2018 Teakdecking Systems, Inc.  All rights reserved.  Reproduction and distribution only after written approval.  |  Accessibility